1. You can adjust the value of bias u₀ and amplitude A by moving the scrollbar:




2. To change the values of frequency, omega:

 

 

First click on the CHANGE button:
 
 







Next, click on the text area and insert new values:
 







 




Then hit the ENTER key, or click on the APPLY button to accept the new values.

3. To rescale the heights of either plots

 

 

First, click on the appropriate ADJUST button:
 







 





Next, click on the text area and insert new values:
 









Then hit the ENTER key, or click on the APPLY button to accept the new values.

(Note: The ADJUST buttons for each plot will work only one at a time. Also, the new maximum value is not allowed to be less the current minimum value, and vice versa.)
 
 

4. To help in reading the plots, click on the PAUSE button:

 










Under the PAUSEd mode, a crosshair and its corresponding time-value and y-value will appear on the top of the panel when the cursor enters the top plot:



(Note: A verticle crosshair appears on the bottom plot to help measure time shifts.)

The pair of crosshair will disappear once the RESUME button is clicked.
 

5. Before sending the page to printout, place some text in the appropriate areas located in the lower left section for both some notes as well as the group members' names ( space is allotted only for 3 members.)

 







 




6. Prior to printing, it is strongly suggested to first PAUSE the simulation. In order to printout the full page, change the settings for your printer to Landscape mode.

This page is maintained by Tomas B. Co (tbco@mtu.edu). Last revised 2/7/1999.

     Tomas B. Co
     Associate Professor
     Department of Chemical Engineering
     Michigan Technological University
     1400 Townsend Avenue
     Houghton, MI 49931-1295

Back to Homepage